Install the battery pack and card – Sanyo VPC-MZ3 User Manual
Page 31
Install the battery pack and card
The card can be used after it has been formatted with the camera (see
FORMATTING A CARD on page 35). Be sure to turn off the power before
installing or removing the card.
Use the battery pack recharged in step 1 above.
Make sure that the battery pack polarity ((+) and (–)) and the card orientation
are correct.
5
Insert the battery pack.
6
Insert the card
1
Open
[
j
] mark
2
Push in
3
Pull out
Open battery compartment cover
on the digital camera side.
Close the battery compartment
cover.
Insert the battery pack.
œ
When removing the battery pack...
Push the card cover lever.
Close the card cover.
Insert the card all the way.
œ
When removing the card...
2
Push in
1
Push
3
Pull out
SX612/EX, GX, U (VPC-MZ3 GB2) Thu. Sept., 05/2002
English
28