Sharp XG-C40XU - Manual (Page 20)

E-19
Operation
Basic Operations
4
3
3 Slide the zoom knob. The image can be adjusted
to the desired size within the zoom range.
4 Slide the focus knob until the image on the screen
becomes clear.
5 Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
EXAMPLE
• When no signal is being received, “NO SIGNAL” will be
displayed. When a signal that the projector is not preset
to receive is being received, “NOT REG.” will be displayed.
6 Press VOLUME ؀/؁ to adjust the volume.
7 Press MUTE to temporarily turn off the sound.
Press MUTE again to turn the sound back on.
8 Press POWER OFF.
Press POWER OFF again while the message is
displayed.
• If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the power off screen
disappears.
• When POWER OFF is pressed twice, the POWER indicator
will illuminate red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing POWER
ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator illuminate green.
• The POWER indicator flashes if the bottom filter cover is
not securely installed.
6
7
8
5
5 INPUT 1 Mode
f d
g
s
INPUT 4
(S-VIDEO) Mode INPUT3
(VIDEO) Mode
INPUT 2 Mode
6
7
8