Spirit XR895 - Manual (Page 22)

XU875 & XR895
21
Console Operation
Quick Start
This is the quickest way to start a workout. After the console powers up you just press the Start
key to begin. This will initiate the Quick Start mode. In Quick Start the Time will count up from zero,
all workout data will start to accrue and the workload may be adjusted manually by pressing the
Up or Down buttons. The dot matrix display will show only the bottom row lit at first. As you
increase the workload, more rows will light indicating a harder workout. The bike will get harder to
pedal as the rows increase. The dot matrix has 20 columns of lights and each column represents 1
minute. At the end of the 20
th
column (or 20 minutes of work) the display will wrap around and start
at the first column again.
There are 40 levels of resistance available for plenty of variety. The first 10 levels are very easy
workloads, and the changes between levels are set to a good progression for de-conditioned
users. Levels 10-20 are more challenging but the increases from one level to the next remain
small. Levels 20-30 start getting tough as the levels jump more dramatically. Levels 30-40 are
extremely hard and are good for short interval peaks and elite athletic training.
Basic information
The Dot Matrix, or Profile window, has two display modes. When you begin a program the dot
matrix will display the workout Profile. To the left of the dot matrix there is a button labeled Display.
Pressing this button once will switch the display to show a quarter mile track. If the Display button
is pressed again the dot matrix will switch back and forth between Track and Profile mode every
few seconds. To turn off the scan mode press the Display key again. This will return you to the
profile display mode.
The Message Window will initially be displaying Time and Distance information. On the bottom
left of the message window is a button labeled Display. Each time this Display button is pressed
the next set of information will appear, four windows in all. In order: Time and Distance, Pulse and
Calories, Speed in RPM and MPH, Work Level and Watts. If the Display button is pressed during
the Level and Watts display the Scan light will come on and the message window will show each
set of data for four seconds then switch to the next set of data in a continuous loop. Pressing the
Display button again will bring you back to the beginning.
To the right of the Dot matrix display is a Heart Icon and a Bar Graph. The Bike has a built in
heart rate monitoring system. Simply grasping the hand pulse sensors, or wearing a chest strap
heart rate transmitter, will start the Heart Icon blinking (this may take a few seconds). The
Message Window will display your heart rate, or Pulse, in beats per minute. The Bar Graph
represents the percentage of your maximum heart rate you are currently achieving. NOTE: You
must enter your age for the Bar Graph to be accurate. Refer to Heart Rate section for details
about these features and how they can help you work out more efficiently.