beautypg.com

Using the battery pack, Data battery system, Tton – JVC GR-D340EK User Manual

Page 13: Pg. 13), Getting started

background image

EN

13

GETTING STARTED

MasterPage: Start_Right

GETTING

ST

AR

TED

To detach the battery pack
Slide the battery pack upward while pressing
PUSH BATT. to detach it.

* Provided

NOTES:

It is recommended that only genuine JVC

batteries are used in this camcorder. Using
generic non-JVC batteries can cause damage
to the internal charging circuitry.

● If the protective cap is attached to the battery

pack, remove it first.

● During charging, the camcorder cannot be

operated.

● Charging is not possible if the wrong type of

battery is used.

● When charging the battery pack for the first time

or after a long storage period, the POWER/
CHARGE lamp may not light. In this case, remove
the battery pack from the camcorder, then try
charging again.

● If the battery operation time remains extremely

short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.

● Since the AC Adapter processes electricity

internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.

● Using the optional AA-VF7 Battery Charger, you

can charge the BN-VF707U/VF714U/VF733U
battery pack without the camcorder.

● After 5 minutes has elapsed in Record-Standby

mode with the cassette inserted, and no operation
is performed (

“T PAUSE” indicator may not

appear), the camcorder will automatically turn off
its power supplied from the AC adapter. In this
case, the battery charge starts if the battery is
attached to the camcorder.

Using The Battery Pack

Perform steps

23 in “Charging The Battery

Pack”.

Maximum continuous recording time

* Provided

NOTES:

● Recording time is reduced significantly under the

following conditions:
• Zoom or Record-Standby mode is engaged

repeatedly.

• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.

● Before extended use, it is recommended that you

prepare enough battery packs to cover 3 times the
planned shooting time.

ATTENTION:

Before detaching the power source, make sure that
the camcorder’s power is turned off. Failure to do so
can result in a camcorder malfunction.

Data Battery System

You can check the remaining battery power and
the recordable time.
1) Make sure the battery is attached and the
Power Switch is set to “OFF”.
2) Open the LCD monitor fully.
3) Press DATA, and the battery status screen
appears.

● It is displayed for 5 seconds if the button is

pressed and released quickly, and for 15
seconds if the button is pressed and hold for
several seconds.

● If “COMMUNICATION ERROR” appears

instead of the battery status even though you
tried to press DATA several times, there may
be a problem on the battery. In such a case,
consult your nearest JVC dealer.

Battery pack

Charging time

BN-VF707U*

Approx. 1 hr. 30 min.

BN-VF714U

Approx. 2 hr. 40 min.

BN-VF733U

Approx. 5 hr. 40 min.

Battery pack

LCD monitor

on

Viewfinder on

BN-VF707U*

1 hr. 30 min.

1 hr. 40 min.

BN-VF714U

3 hr.

3 hr. 25 min.

BN-VF733U

7 hr.

8 hr.

G R-D340PAL.bo o k Pag e 13 Thursday , Oc t

o ber 27 , 2005 3:19 PM