Star Micronics SP500 Series - Manual (Page 3)

- 4 - - 5 -
POWER lamp
7. After the automatic paper feed has been completed, the POWER lamp (green) on
the operating panel will blink.
７ . 在自働進紙完成后，操作面板上的 POWER 灯（緑色）閃煉。
10. Wind the paper around the spool for 2 turns.
Note: Use care when winding the paper so that it does not become loose. Also use
care so that the right edged of the paper does not come in contact with the
tab side of the rewinder shaft.
10. 将 纸在轴上绕２圈。
注意 ∶�小心卷纸，谨防松散，以及谨防纸的右侧不与卷纸轴的突出部分粘
在一起。
8. Pass the leading edge of the paper through the slit in the rewinder shaft until it
extends 3 to 4 centimeters beyond it.
８. 将 纸的导引边穿过卷纸轴的压纸条达 3-4 厘米。
9. Fold the paper back so that it is held in place by the slit.
９. 将
纸回折，以固定在压纸条上。
3 to 4 cm