Sony UPD-X100 - Manual (Page 14)

Bluetooth
14
6
Press b or B of the control button to set the
POWER to ON.
7
Press the EXEC button.
“REBOOTING” appears. Then the printer is restarted,
and the Bluetooth lamp lights.
Authentication
What's a passkey
Passkey is used to authenticate two Bluetooth devices
that have not previously connected to each other and
create a trusted relationship between them.
You need to enter the same characters (passkey) to each
device on passkey authentication process. This printer
uses a 4-digit number as a passkey.
Once authentication of the device has been confirmed,
the printer registered the device as a record. Since then
you can connect the device without entering a passkey.
To ensure proper security, the passkey entry has a time
limit (30 seconds), based on the Bluetooth standards.
The passkey entry may be required when the
authentication valid period of the printer or other device
is expired, the record is deleted, or the security setting is
changed.
Passkey entry may be required, depending on devices,
each time you intend to connect.
This “Passkey” is also referred to as a “Bluetooth
passkey” etc. “PIN” is also used with the same meaning.
When the passkey entry screen appears
on the other device
Enter the desired passkey on your printer. Then, enter
the same passkey on the other device
Entering the passkey
Enter the same passkey on the printer and the other
device to be connected, as follows:
1
Turn on the printer.
“Ready BT RSSI [----]”appears on the operation
display.
2
Press the MENU button.
3
Press V of the control button to display “Bluetooth
SETTING [>>].”
4
Press B of the control button.
“Bluetooth ADDR” appears.
5
Press V of the control button to display
“PASSKEY INPUT [>>].”
6
Press B of the control button.
“PASSKEY INPUT <1> [X:X:X:X]” appears.
| |
Current digit to be set Passkey
7
Press b or B of the control button to select a digit
of the passkey to be set.
This <1> shows the leftmost digit, and <4> shows
the rightmost digit.
8
Press v or V of the control button to set the value
of the passkey.
Value from 0 to 9 can be used.
Repeat Steps 7 and 8 until the four-digit passkey is
set.
9
Press the EXEC button.
“PASSKEY INPUT Saving. . .” appears, and your
passkey setting is stored.
10
When the setting is completed, press the MENU
button.
ALARM
PRINT
MENU
EXEC
DIGITAL PHOTO PRINTER
1
1 2,10 7 4,6
3,5 9 8