Southbend ROTARY TABLE SB - Manual (Page 7)

-5-
SB1363-64/SB1367-68 Mfg. Since 10/09 P R E P A R AT i O n
This item was carefully packaged to
prevent damage during transport.
If you discover any damage, please
immediately call Customer Service
at (360) 734-1540 for advice. You
may need to file a freight claim, so
save the containers and all packing
materials for possible inspection by
the carrier or its agent.
inventory Preparation Overview
The purpose of the preparation
section is to help you prepare your
rotary table for operation. The list
below outlines the basic process.
Specific steps for each of these
points will be covered in detail later
in this section.
The typical preparation process is as
follows:
1. Unpack the tool and inventory
the contents.
2. Clean the tool and its
components.
3. Install the rotary table on
the mill table horizontally or
vertically.
4. Align the rotary table with the
mill spindle centerline.
Required for Setup
The items listed below are required
to successfully set up and prepare
this tool for operation.
• Safety glasses
• Cleaner/degreaser (see Page 6)
• Clamping hardware and tools
• Custom keys for horizontal
installation (see Page 7)
(Optional)
• Machinist's square
• Test indicator
• Edge finder (Optional)
Description (Figure 2) Qty
A. Rotary Table . . . . . . . . . . . . . . 1
B. Handwheel Handle . . . . . . . . . 1
Figure 2. Shipping inventory.
A
B