Sanyo MBR-1404GR - Manual (Page 20)

19
ROUTINE MAINTENANCE
WARNING
Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in
order to prevent electric shock or injury.
Ensure you do not inhale or consume medication or aerosols from around the unit at the time of
maintenance. These may be harmful to your health.
Cleaning of cabinet
■ Clean the unit once a month. Regular cleaning keeps the unit looking new.
■ Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all
accessories. If some of them are dirty, use a cloth containing diluted neutral dishwashing detergent
(Undiluted detergent may break the plastic parts. For the dilution, follow the instruction enclosed with
the detergent). When a diluted neutral dishwashing detergent is used, wipe the cabinet or accessories
thoroughly with a cloth soaked in clean water. Then wipe the cabinet or accessories unit with a dry cloth
to eliminate the moisture.
■ Never pour water onto or into the unit. Doing so can damage the electric shock or short circuit.
■ The compressor and other mechanical part are completely sealed. This unit requires absolutely no
lubrication. There is a fan behind the compressor, so be very careful if you stick your hand into this part
of the unit.
Cleaning of condenser filter
1. Lift front cover by pulling firmly on both lower corners of
the panel.
2. Take out the shaft, and insert end of a shaft in black hole
of the front cover. This will keep the cover from falling
back.
3. Tug gently on black tab on lower center of condenser filter
to remove the filter.
4. Clean filter with a vacuum cleaner or water.
5. Thoroughly dry filter if using water to clean it.
6. After cleaning the condenser filter, return it to the original
position.
Front cover
Condenser
filter Shaft