beautypg.com

Control/address settings, Control switch, Address switch – Sanyo MEGAPIXEL VCC-HD5400 User Manual

Page 12

background image

11

Control/Address Settings

When you connect the camera to a controller, it is necessary to configure the interface board control
switch and address switch.

Control switch

This is used to configure transmission rate and protocol, etc.

Switches 2 and 3 are not used.
Settings in bold typeface in the table below show the factory default
configurations.

Baud Rate

Configure the transmission rate of connected devices to the transmission
rate of the camera.

Transmission Rate

Switch 6

Switch 5

2400

OFF

OFF

4800

ON

OFF

9600

OFF

ON

19200

ON

ON

When protocol is set to “PELCO”, set to 2400.

Protocol

Select the protocol for controlling the camera.

Protocol

Switch 4

Corresponding Protocol

SSP (SANYO)

OFF

Automatic switching between Sanyo SSP and high speed SSP

PELCO

ON

Automatic switching between PELCO-D and PELCO-P

Terminator

When you connect multiple cameras, set the terminator setting (Switch 1) of the final device to “ON”
and all other devices to “OFF”.

Address switch

If you use the RS485 communication mode, assign a unique address (camera No.) to each camera.

ON

1

2

3

4

5

6

7

8

Configure the address by setting the dip switches to “ON” and “OFF”.

For further information, refer to the “Address Settings Table” on
the next page.

ON

6

5

4

3

2

1

ON

6

5

4

3

2

1

This manual is related to the following products: