Sony KP 48V85 - Manual (Page 16)

12
Installing and Connecting the Projection TV (continued)
Connecting a satellite receiver
(SAT) and a VCR
1 Connect the cable from the satellite
antenna to the satellite receiver.
2 Attach the coaxial cable from the
incoming cable connection or antenna to
VHF/UHF IN on the VCR.
3 Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4 Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
satellite receiver to AUDIO and S VIDEO
IN on the VCR.
5 Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
VCR to AUDIO and S VIDEO IN on the
projection TV (White-AUDIO Left, Red-
AUDIO Right).
* If your VCR is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO
cable.
Note:
• To view input from the satellite receiver or
VCR, select the video input which your
satellite receiver or VCR is connected to
by pressing TV/VIDEO on the remote
control.
Disconnect all power sources before making any connections.
VMC-810S/820S
(not supplied)
4
VCR
YC-15V/30V (not supplied)
5
1
S VIDEO
2
AUDIO-L
Coaxial cable
(Rear of projection TV)
Satellite
antenna
cable
3
VIDEO
AUDIO-R
VMC-810S/820S (not supplied)
YC-15V/
30V
(not
supplied)
SAT
Cable/
Antenna
S VIDEO
S-LINK S-LINK
VIDEO
AUDIO
L
R R
VIDEO
L
AUDIO
VHF/UHF
AUX
(MONO)
IN
IN
VIDEO 1 VIDEO 3 VIDEO 4
OUT
MONITOR AUDIO
(VAR/FIX)
TV
VIDEO 5
VIDEO 1 VIDEO 3 VIDEO 4 VIDEO 5
TO
CONVERTER
Y
P B
P R
R
L
(MONO)
AUDIO
OUT
MONITOR
AUDIO
(VAR/FIX) TV
LINE
OUT
OUT
IN
AUDIO R AUDIO L VIDEO S VIDEO
VHF/UHF
LINE
IN
LINE
OUT
OUT
IN
VHF/UHF
SATELLITE IN
S VIDEO AUDIO R AUDIO L VIDEO