beautypg.com

Standard Horizon CP1000C User Manual

Page 29

background image

GPS chartplotters

Page 31

1. Press [MENU] , select SETUP and press [ENTER] or move the shuttlepoint knob to the

right.

2. Move the ShuttlePoint knob to GENERAL SETUP and press [ENTER] or move the

ShuttlePoint knob to the right.

3. Move the shuttlepoint knob to TIME SETUP and press [ENTER] or move the

shuttlepoint knob to the right.

4. Move the shuttlepoint knob to GPS TIME OFFSET and press [ENTER] or move the

shuttlepoint knob to the right.

5. Move the ShuttlePoint knob down to select +00:00 , press [ENTER] and move the

ShuttlePoint knob to the right to edit the number.

6. Look at the table and find the offset for your area. You will need to enter this offset to

make the GPS chartplotter show the correct time.

7. Move the Shuttlepoint knob the “+”. Move the ShuttlePoint knob up or down to change

to the desired offset.

8. Next move the ShuttlePoint to the right to select Hours and move the ShuttlePoint up

or down to change the hour.

9. Repeat this method to change the minutes if necessary.

10. Once you have the correct GPS time offset, press [ENTER] to set.

3.3

SELECTING LORAN TD OR OTHER COORDINATE SYSTEM

The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TD’s or UTM.
Below is the window that will appear when customizing the coordinate system.

Figure 3.3 - Coordinate System Menu

1. Press [MENU] and move the ShuttlePoint knob to select SETUP.
2. Move the ShuttlePoint knob to ADVANCED SETUP and press [ENTER] or move the

ShuttlePoint knob to the right.

3. Move the shuttlepoint knob the select NAVIGATE.
4. Press [ENTER] or move the ShuttlePoint knob to the right and select COORDINATE

SYSTEM.

5. Press [ENTER] or move the ShuttlePoint knob to the right to show the coordinate

selection popup window.

6. Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENTER]

or move the ShuttlePoint knob to the right.

7. Press [CLEAR] or move the ShuttlePoint knob to the left until the chart page is shown.

NOTE

If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are

This manual is related to the following products: