Sony Ericsson G30 - Manual (Page 30)

Troubleshooting
30 Fixed Wireless Terminal: G30 and G35 models
LED indicators status
If you see… It means… Do this…
Power LED Green
Radio LED ON or
flashing
AC power is ON.
The FWT is connected
to the cellular network
and available for use.
Normal operation mode
Start using your FWT.
If Radio LED is flashing, Please
refer to the topic FWT Location
on page 12.
If you are unable to make a
call, check the telephone
cable connection or the PBX
connections and program.
Both LEDs OFF AC Power is OFF
Verify that the AC power plug
is securely connected to the
AC power outlet.
Check that the DC power cord
is connected to the FWT.
Check the circuit breaker or
fuse for the AC electrical circuit
that supplies power to the AC
outlet that the FWT is
connected too.
Power LED Green
Radio LED OFF
AC Power is ON
The FWT is not
connected to the cellular
network. The FWT is not
available for use.
Verify that the antenna is
properly installed.
Verify you have installed the
FWT in the best location and
that the antenna is properly
connected. Please refer to the
topic FWT Location on page
12.
Power LED Red
Radio LED Green
or flashing
AC power is OFF. The
FWT is operating using
the battery back-up
power
The FWT is connected
to the cellular network
and available for use.
Verify that the AC power cords
are securely connected to the
AC power outlet.
Check that the power cable is
connected to the FWT.
Check the circuit breaker or
fuse for the AC electrical circuit
that supplies power to the AC
input of the FWT power supply.
Power LED Red
Radio LED OFF
AC power is OFF. The
FWT is operating using
battery back-up power.
The FWT is not
connected to the cellular
network. The FWT is not
ready for use.
Verify that the AC power cord
is securely connected to the
AC power outlet.
Check that the power cable is
connected to the FWT.
Check the circuit breaker or
fuse for the AC electrical circuit
that supplies power to the AC
outlet that the FWT is
connected to.
Both LEDs Flashing
(simultaneously)
Alarm status
The FWT is blocked or it
has an internal fault
Check the alarm status table
above.
Contact your distributor or
network operator for
assistance.