Sierra Monitor Corporation ZSE30 - Manual (Page 17)

Connector
Connector Connecting/Disconnecting
•When connecting the connector, insert it straight onto the pin holding the lever and connector body
between fingers and lock the connector by pushing the lever claw into the square groove in the housing.
•When disconnecting the connector, push down the lever by thumb to disengage the lever claw from the
square groove. Then pull the connector straight out.
•Please refer the table below for the connector cable (without connector).
Item Specification
Cable O.D.
φ3.4
Core no. 3
Conducted normally
sectional area
0.2mm
2
(AWG25)
Complying standard Complies UL2103
End of terminal
•Use SMC specified connector cable.
If you need different length of lead wire, please contact to SMC sales person.
-16-
PS##-OMF0010-C