Shindaiwa 81704 - Manual (Page 5)

5
Brushcutter Blade
Cutting
Attachment Shield
Gear Case
Throttle
Trigger
Product Description
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
Figure 4
Specifications C2510
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Specifications are subject to change without notice.
n Engine/Outer tube assembly
n Handlebar and Throttle assembly
n Cutting attachment
n Kit containing cutting attachment shield
mounting bracket and hardware, this
owner’s/operator’s manual and tool kit
for routine maintenance. Tool kits vary
by model and may include a hex wrench
set, a spark plug/screwdriver combina-
tion wrench, and a spanner.
This unit comes fully assembled with the
exception of the handlebar cutting attach-
ment shield and cutting attachment.
WARNING!
Do not make unauthorized modifica-
tions or alterations to any of these units
or their components.
C2510 BRUSHCUTTER
Outer Tube
Handle Bar
Ignition
Switch
Fuel
Tank
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Muffler
Spark Plug
Harness
Throttle
Interlock
Air cleaner type .................................... Non-reversible heavy-duty
two-stage filter element
Starting method ...................................................................... Recoil
Stopping method ........................................................... Slide switch
Transmission type .............................Automatic, centrifugal clutch
w/bevel gear
EPA Emission Compliance Period** ............................ Category A
** The EPA emission compliance referred to on the emission com-
pliance label located on the engine, indicates the number of
operating hours for which the engine has been shown to meet
Federal emission requirements. Category C = 50 hours (Moderate),
B = 125 hours (Intermediate) and A = 300 hours (Extended).
C2510X dry weight
(less attachments) ..................................................... 11.5 lb./5.2 kg
Engine model ..................................................................... SF2510E
Engine type ......................................... with Power Boost Chamber
Bore x stroke ............................................. 1.3 x 1.1 in./34 x27 mm
Displacement ....................................................... 1.5 cu. in./ 24.5 cc
Maximum power ...................................................... 1.1 HP/0.8 kW
@ 7500 rpm (min-1)
Fuel/oil ratio .............................. 50:1 with ISO-L-EGD or JASO FC
class 2-cycle mixing oil*
Carburetor type ................................Walbro WYL, diaphragm-type
Fuel tank capacity .................................................... 20.3 oz./600 ml
Ignition ........................................................... One-piece electronic,
program-controlled
Spark plug ................................................................... NGK CMR5H
* meets or exceeds these specifications and is recommended for
all Shindaiwa products.