Siemens Mux_guide_v06 - Manual (Page 30)

Multiplexer User's Guide
Confidential / Released
s
m
o b i l e
Mux_guide_v06 Page 30 of 36 30.06.2004
4.3.10 Power saving control (PSC)
The power saving control message uses the following type field octet:
Type:
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8
1 C/R 0 0 0 0 1 0
C/R bit: Indicates whether the sequence is a command or a response.
Length:
The length byte contains the value 0 (no value octet) or 1 (one value octet).
Value octet (Length=1)
Bit 1 Bit 2 Bit 3 Bit 4 Bit 5 Bit 6 Bit 7 Bit 8
P1 P2 P3 P4 0 0 0 0
The P-bits are defining the parameter value.
In commands:
Bit 1 Bit 2 Bit 3 Bit 4 Description
0 0 0 0 Switches to the same mode as without a
value octet
1 0 0 0 Switches into full functionality mode, like
AT+CFUN=1
0 1 0 0 Switches into NON-CYCLIC SLEEP mode,
like AT+CFUN=0
1 1 0 0 Switches into CYCLIC SLEEP mode, like
AT+CFUN=5
0 0 1 0 Switches into CYCLIC SLEEP mode, like
AT+CFUN=6
1 0 1 0 Switches off, like AT^SMSO
0 1 1 0 Resets, like AT+CFUN=1,1
1 1 1 0 Switches into CYCLIC SLEEP mode, like
AT+CFUN=7
0 0 0 1 Switches into CYCLIC SLEEP mode, like
AT+CFUN=8
All wake up events and details of the CYCLIC and NON-CYCLIC SLEEP mode are specified
in [2].
In responses:
Bit 1 Bit 2 Bit 3 Bit 4 Description
0 0 0 0 Failure
1 0 0 0 Success
Figure 12: Power Saving Control (PSC)