Siemens WTXD5522UC - Manual (Page 17)

17
Operation
Using the dryer
1. Open the door.
2. Check lint filter.
The filter should be cleaned after
and before every drying process.
Cleaning the filter reduces the
drying time and saves energy.
3. Rotate program selector to the
desired program.
Select the program which
corresponds to the laundry in the
dryer from the program selection
table (see page 16).
The dryer light turns on inside the
drum.
i The Start/Stop" indicator light
starts flashing.
4. If required, select option" by
pressing the button.
The "options" are explained on
page 15.
5. Place laundry in the empty drum.
Put each piece of laundry into the
machine separately.
For best results the laundry to be
dried must be sorted according to
type of laundry and desired degree
of drying. For further information
see page 14.
i Observe drying symbols of the
laundry manufacturer. If drying
woolen clothing and shoes, see
the information on page 18.
Ensure that there is only laundry in the
drum. Check that all items are
completely in the drum.
6. Close the door.
The start/stop" indicator light
continues flashing.
i If the door has not been closed
properly, the dryer will not start.
7. Press the start/stop" button. The
start/stop" indicator light
illuminates.
i The program starts with an
acoustic signal (if set).
If a standard program has been
selected, the indicator lights indicate
the progress of the program sequence.
i At program end an acoustic signal
is emitted (if set) and the LED
antiWrinkle" illuminates.
i When the drying process is
complete (program or selected
time program ended), the drum
rotates at specific intervals for
1 hour.
This prevents the laundry from
creasing. The laundry remains
loose and fluffy until it is removed.
The laundry should be removed
before this time has elapsed.
8. Open the door.
9. Take the laundry out of the dryer.
10. Rotate the program selector
to off".
The dryer light goes out.
11. Clean the filter.
The filter should be cleaned after
each drying process. Cleaning the