Sirius Satellite Radio SIR-SL1C - Manual (Page 13)

Streamer GT SIR-SL1C User Guide
1
Vehicle Installation: Running the Antenna Cable
1. Turn the SIR-SL1C receiver power OFF and
remove it from the mount; unplug the Car Power
Adapter from the cigarette lighter; unplug the
antenna from the Receiver.
2. Route the cable from the antenna to the vehicle’s
interior by tucking it underneath the rubber
molding around rear window, as shown.
3. Route the cable from the lowest point of the rear
window into the trunk. Take advantage of any
existing cable channels or wiring conduits.
• For SUVs, minivans & 5-door vehicles, bring the
cable into the vehicle under the rubber molding for
the tailgate, and continue under the interior trim.
4. From the trunk, route the cable around the passenger
compartment and to the back of the cradle.
• Do not pull the wire across sharp edges that could
damage it.
• Keep the wire away from areas where it could
become tangled in driver’s and passenger’s feet.
5. Plug the antenna back into the SIR-SL1C Receiver’s
ANTENNA jack.
6. Plug the car power adapter into the cigarette lighter.
IT IS RECOMMENDED THAT YOU UNPLUG THE
CAR POWER ADAPTER AFTER THE VEHICLE’S
IGNITION IS TURNED OFF.