Info. additional information, Referenced documents, Chapter info. additional information – Socket Mobile Ethernet Blaster Communications Cable User Manual

Page 33

Altera Corporation

EthernetBlaster Communications Cable User Guide

Info. Additional Information

Referenced Documents

For more information on configuration and in-system programmability (ISP), see the
following sources:

■

AN 39: IEEE 1149.1 (JTAG) Boundary-Scan Testing in Altera Devices

■

AN 95: In-System Programmability in MAX Devices

■

Configuring Cyclone FPGAs

chapter in volume 1 of the Cyclone Device Handbook

■

Configuring Cyclone II Devices

chapter in volume 1 of the Cyclone II Device Handbook

■

Configuring Stratix and Stratix GX Devices

chapter in volume 2 of the Stratix Device

Handbook

■

In-System Programmability Guidelines for MAX II Devices

chapter in volume 1 of the

MAX II Device Handbook

■

Serial Configuration Devices Data Sheet

■

Programming & Configuration chapter in the

Introduction to Quartus II manual

■

The Programming module of the Quartus II online tutorial

■

Refer to the following glossary definitions in Quartus II Help:

■

“EthernetBlaster Cable” (general description)

■

“Configuration scheme” (general description)

■

“Programming files” (general description)

■

Refer to the following procedures in Quartus II Help:

■

Programming a Single Device or Multiple Devices in JTAG or Passive Serial
Mode

■

Programming a Single Device in Active Serial Programming Mode

■

Selecting the Communications Cable for the SignalTap II Logic Analyzer

■

Refer to the following introduction and overview topics in Quartus

II Help:

■

Programmer Introduction

■

Overview: Working with Chain Description Files

■

Overview: Converting Programming Files