Socket Mobile Ethernet Blaster Communications Cable - Manual (Page 31)

Chapter 3: EthernetBlaster Communications Cable Specifications 3–3
Operating Conditions
© June 2008 Altera Corporation EthernetBlaster Communications Cable User Guide
1 The circuit board must supply VCC(TARGET) and ground to the EthernetBlaster
cable for the I/O drivers.
Circuit Board Header Connection
The circuit board's 10-pin male header, which connects to the EthernetBlaster cable's
10-pin female plug, has two rows of five pins. These pins are connected to the device’s
programming or configuration pins.
Figure 3–3 shows the dimensions of a typical 10-
pin male header.
1 Although a 10-pin surface mount header can be used for the JTAG, AS or PS
download cable, Altera recommends using a through-hole connector due to the
repeated insertion and removal force needed.
Operating Conditions
Table 3–3 through Table 3–5 summarize the maximum ratings, recommended
operating conditions, and DC operating conditions for the cable.
5 nCONFIG Configuration
control nCONFIG Configuration
control TMS JTAG state
machine control
6 nCE Cyclone chip enable — No connect — No connect
7 DATAOUT Active serial data
out nSTATUS Configuration
status — No connect
8 nCS Serial configuration
device chip select — No connect — No connect
9 ASDI Active serial data in DATA0 Data to device TDI Data to device
10 GND Signal ground GND Signal ground GND Signal ground
Table 3–2. EthernetBlaster Female Plug Signal Names & Programming Modes (Part 2 of 2)
Figure 3–3. 10-Pin Male Header Dimensions
0.025 Sq.
0.235
0.100
0.100
Dimensions are shown in inches.
Top View Side View
Table 3–3. EthernetBlaster Cable Absolute Maximum Ratings
Symbol Parameter Conditions Min Max Unit
V
CC(TARGET)
Target supply voltage With respect to ground –0.3 5.5 V
V
CC(SYS)
System supply voltage With respect to ground –0.5 14.0 V