SIIG Transport GX21 B5350 - Manual (Page 39)

3.5 Replacing the storage backplane
Chapter 3: Replacing installed components 33
1. Remove the front panel ribbon cable from the rear of the
LED control panel.
2. Remove the two screws that secure the LED control
panel to the chassis and lift the board free of the chassis.
3.5 Replacing the storage backplane
This section describes how to replace the S-ATA backplane
on your Transport GX21 (B5350).
1. Remove the chassis cover as described in section 2.2.1
Removing the chassis cover.
2. Remove all cables connected to the S-ATA backplane,
including power cables, and S-ATA data cables.