Sharp CV-2P10SC - Manual (Page 28)

EN-26
Drain out water within the unit in the following cases.
• When the unit stops operating and the TIMER, AIR CON and MAXIMUM lamps are
blinking, the water tank is full and need to be drained.
• When the unit is not used for a long time.
1
Unplug the power plug and carefully move
the unit to a drain or outside to avoid wa-
ter spilling out into the room.
2
Remove the stopcock from the drainpipe,
and drain water within the unit.
3
Replace the stopcock securely to the
drainpipe.
MAIN UNIT OPERATION
1
1
Press the POWER button to start opera-
tion.
• The mode will change as you press the button
within 5 seconds.
• In cool mode, the unit will operate at its last
cooling settings. If the unit has been unplugged
since it was last operated, it will resume opera-
tion in the cooling mode, set at 68˚F. The fan
speed set to AUTO.
TO TURN OFF
Press the POWER button during opera-
tion.
Stopcock
Drainpipe
DRAINAGE
Use this operation when the remote control is not available.
COOL
(The green AIR CON lamp will light)
ION GENERTOR
(The blue ION GENERATOR lamp will light)
OFF
CV-2P10SC_en.indd 26 11.3.22 11:00:19 AM