beautypg.com

Replacing the air filter, Oth e rs – Sony Cineza VPL-HS2 User Manual

Page 32

background image

Oth

e

rs

GB

32

Replacing the Air Filter

6 While pushing the projector cover toward

you by holding both sides of the cover on
the lens side, close the cover until it clicks.

7 Connect the power cord and set the

projector to standby mode.

8 Press the following buttons on the remote

control in the following order for less than
five seconds each: RESET,

<

,

,

, ENTER.

Notes

• Do not put your hands into the lamp replacement spot, and do

not allow any liquid or object to fall into it to avoid electrical
shock or fire.

• Be sure to use the LMP-H150 Projector Lamp for replacement.

If you use lamps other than LMP-H150, a malfunction may
occur.

• Be sure to turn off the projector and unplug the power cord

before replacing the lamp.

Disposal of the used lamp

As the used lamp contains Mercury, dispose of the
lamp according to local, state or federal laws.

As the materials used in this lamp are similar to those
of a fluorescent lamp, you should dispose of a used
projector lamp in the same way as a fluorescent lamp.

Replacing the Air Filter

The air filter should be replaced periodically. When
“Please replace the filter.” appears on the screen,
replace the air filter immediately.

Notes

• Replacing the air filter is very important to maintain the high

efficiency of the projector and to prevent a malfunction. When
the replacement message appears on the screen, replace the air
filter without delay.

• When removing the air filter from the projector, be careful that

no dust or object gets into the inside of the projector.

• Before replacing the air filter, turn off the projector and unplug

the power cord.

1 Hold down the adjuster lock lever, slide it

to the right, raise the rear of the projector,
then return the adjuster lock lever. While
keeping the screw on the bottom of the
projector turned inward with a coin or a
slotted screwdriver, open the projector
cover with your hand.

Note

Be sure that the projector is stable.

2 Push the filter lock knob to remove the

filter cover.

3 Remove the air filter from the filter holder

by holding the tab on the air filter.

1

2

Air filter

Filter holder