Sharp LL-T1820-B - Manual (Page 10)

10
Product description
1 2 3 4 5 6 7 9 11
12
10
13
8
1. INPUT button ............................ To switch between the signal’s input terminals. (Input terminal 1
↔ Input
terminal 2)
2. MENU button ............................ This button is used to pop-up, select and close the OSD (On Screen
Display) Menu.
3. SELECT button ........................ This button is used to select menu options when the OSD Menu is dis-
played.
4. buttons .............................. When the OSD Menu is displayed:
These buttons are used to increase or decrease the value of a selected
option.
When the OSD Menu is not displayed:
These buttons are used to adjust backlight brightness .
5. Power button
6. Power LED ................................ This LED is lit green when in use and orange when in power-saving mode.
7. USB port (downstream: 2 ports)
8. USB port (upstream: 1 port)
9. DVI-I input terminal ................... The computer’s digital RGB output terminal or analogue RGB output
terminal can be connected here.
For a digital signal input: It can be connected to a computer with a DVI-
compatible output terminal (DVI-D24 pin or DVI-I29 pin) and which has
SXGA output ability. Depending on the computer to be connected, correct
display may or may not be possible.
10.Security lock anchor ................. By connecting a security lock (purchased separately) to the security lock
anchor, the monitor is fixed so that it cannot be transported.
The security slot works in conjunction with Kensington Micro Saver
Security Systems.
11.Power terminal
12.Main power switch
13.Ventilation openings .................. Note: Never block the ventilation openings as this may lead to overheat-
ing inside the monitor and result in malfunction.