Sharp XE-A201 - Manual (Page 66)

64
Removing the paper roll
When a red dye appears on the paper roll, it is time to replace it. Replace the paper roll with new one. If you
plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate
place.
Caution: The paper cutter is mounted on the cover. Be careful not to cut yourself.
When the take-up spool is not used:
1. Turn the mode switch to the REG position with the power cord connected.
2.
Remove the printer cover.
3.
Cut the paper behind the printer and near the paper roll.
4. Press the
F
key until the paper remaining in the printer comes out
completely.
5. Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
When the take-up spool is used:
1.
Turn the mode switch to the REG position with the power cord connected.
2. Remove the printer cover.
3. Press the
F
key to advance the journal paper until its printed part is out of
the way.
4.
Cut the paper and remove the take-up spool.
5.
Cut the paper behind the printer and near the paper roll.
6. Press the
F
key until the paper remaining in the printer comes out
completely.
7.
Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
8. Remove the outer side of the take-up spool as shown
on the left.
9.
Remove the printed journal roll from the take-up spool.
Area to
cut
A201_5 OPERATOR MAINTENANCE 01.11.11 10:24 AM Page 64