Siemens WFXD5200UC - Manual (Page 25)

24
Troubleshooting of Minor Faults
d DANGER! d
RISK OF ELECTRIC SHOCK!
Repairs should only be carried
out by an authorized technician.
If repairs are necessary, and you
cannot eliminate the fault yourself
with the aid of the following table:
q Turn the program selector to
off.
q Disconnect the washing
machine from the power outlet.
q Turn off the water tap.
q Call Customer Service
(refer to Page 26).
Fault Possible cause Action
The door cannot be no final spin" selected. Select drain or spin.
opened.
Power failure. An interrupted program will be resumed when power
is restored. If the laundry is to be removed during
a power failure, call Customer Service
(refer to Page 26).
Program is running and/or the door is locked for
safety reasons.
Wait until the program ends; see Page 21.
Plug is loose or not inserted. Eliminate the cause.
Program selector turned to off before end of
program.
Select a program.
Door cannot be opened,
even though the
appliance has been
switched off and on
again.
For safety reasons the door has been locked because
the water level, temperature or speed is too high.
See "Add a garment/Interrupting the program",
Page 21.
Control lights do not light A fuse has blown. Replace the fuse of the individual circuit. g g
up.
Call Customer Service if this fault recurs.
Power failure. An interrupted program will be resumed when power
is restored. If the laundry is to be removed during a
power failure, call Customer Service
(refer to Page 26).
Program does not start.
start/pause indicator
light flashes.
start/pause button not pressed. Press the start/pause button.
Program does not start.
Indicator light end" is lit
Door not closed properly. Check whether laundry is trapped in door.
Indicator light end" is lit
and display is flashing
E:01"
Close the door (a click should be heard).
Program continues.
Spin speed cannot be
selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Select speed before spinning.
Program selector is set to drain; spin cycle is not
possible with this program.
If required, select another program.