Sharp 32N-S500 - Manual (Page 28)

28
Operation of Remote Control (Continued)
L HOW TO IDENTIFY A VCR
The remote control may already be set to operate your VCR. Try
this initial check to see if going on to the following “identify” section
is necessary.
(1) Point remote towards VCR and press VCR POWER.
(2) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR and no further
steps are needed.
• If no, continue to the “identify” section.
L To Identify Your VCR – Direct Entry Method.
Use the following steps and list on page 29 to quickly find the
remote control code for your accessory VCR.
• First look up your VCR’s remote control code number before
going through the direct code entry steps control.
• If this procedure does not identify your accessory VCR, use the
Search method of identification (described in the next section).
(1) Slide TV-CATV switch to TV.
(2) Press and hold down DISPLAY and CH DOWN ( 9 ) on your
remote control.
Then release both buttons.
(3) Within ten seconds after releasing DISPLAY and CH DOWN
( 9 ), enter your VCR’s two-digit remote control code number using
REMOTE KEYPAD (refer to list).
• The remote control is now ready to send commands to your
VCR.
Some brands have more than one remote code listed, due to
changes in the remote codes from early to later model years, or
due to format differences (VHS/BETA). In such cases, you may
have to try more than one code to find the code your VCR
accepts.
Depending on the model, year produced, brand, and type of VCR,
some models may not be compatible with the remote control.
L To Identify Your VCR – Search Method.
(1) Slide TV-CATV switch on the remote to TV.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of the VCR.
Point the remote towards the VCR.
Hold down
DISPLAY and CH UP ( 8 ) at the same time. Keep
holding the buttons down.
(4) Watch the Channel Number indicator on the VCR. Channel
numbers will scan up when the VCR has been identified.
Release
DISPLAY and CH UP ( 8 ) as soon as the channel
numbers start to scan up.
The VCR’s remote control code number has been identified, and
the remote is ready to operate the VCR.
REMOTE
KEYPAD
VCR POWER
DISPLAY
CHANNEL
UP (
8 )/
DOWN ( 9 )
TV-CATV
1 2 3
4 5 6
7 8 9
0 100
POWER
TV
VCR
MENU
CATV
PAUSE
PIP
TV
FLASHBACK
INPUT
STOP REC
REW PLAY FF
VCR CH
SWAP FREEZE MOVE SELECT
CM SKIP DISPLAY MUTE
VOL
—
CH
CH
VOL
+
ENTER
A B C D
PERSONAL PREFERENCE
NOTE: