Sony BBV RX100 - Manual (Page 19)

Rx100 installation manual V1.17 29 Aug 08.doc Page 19
BBV Rx 100
Interface Receiver
Addendum to manual for the following dome:
JVC TK-C655B/676/675B combination cameras
Rx100 software RX1_J2V4
Application Notes
The RX 100 provides the following functionality when controlling the above mentioned domes
Variable speed Pan/Tilt.
Zoom/Focus, Autofocus can be enabled/disabled from the dome menu.
16 Full scene presets.
2 preset patrols.
Slow patrol or dome autopan from controller AUTOPAN key
4 alarm inputs driving to preset 1 - 4.
Additional commands:
TK-C676
Tx400DC Tx1000 Tx1500 DM System Sprite, DS, DS2, BX2
OPEN MENU and BACK (Twice) ‘#’1’ #' WASH 1 ‘#’ *889 002 or *889 10 10 2
SET '#' 2 '#' WIPE 2 ‘#’ *889 003 or *889 10 10 3
Togggle ExDR '#' 3 '#' AUTOPAN 3 ‘#’ *889 004 or *889 10 10 4
Cycle Mono Mode '#' 4 '#' LIGHTS 4 ‘#’ *889 005 or *889 10 10 5
RS485 control of dome using the following connections:
Rx100
Description Dome connection
J3-C1 TX- CONTROL RX- (D)
J3-C2 TX+ CONTROL RX+ (C)
Notes:
The alarm output relay opens for approx 5 seconds upon power up. This can be used to signal power loss, etc.
Camera switch settings:
MACHINE ID – set both rotary switches to ‘0’
8 way DIL switch, all OFF apart from 8 which should be ON to enable the RS485 termination, point-to-point, simplex.
On screen display of preset position, HOME - P16 or MANUAL during manual control. The on screen display can be enabled/disabled using dome switch
SW3, ON = Display off, OFF = Display on.
J6 links.
J6/1-2: Link fitted across J6/1 and J6/2 (default) to allow the ExDR and MONO mode status to be displayed. Remove this link if you are programming a dome
camera title and do not want to display the ExDR and MONO status.
J6/4-5: Fitted (default) dome will perform a slow patrol between programmed presets when AUTOPAN pressed. Removed and fitted to J6/3-4 will send
autopan start to the dome.
DOME MENU
Pressing #1 twice will display the dome’s menu. The joystick is then used to navigate through the dome menu. #2 sends a SET command to the dome and #1
twice whilst the menu is displayed sends a BACK command.
If the #1 command doesn’t work press a focus key before sending #1.
Pressing #1 FOUR times within 2 seconds will display the dome’s service menu.
PRESET POSITIONS
The dome has a home preset position which is preset 00.
To enable this preset to be programmed when using the Rx100/JVC676 programming preset 1. BBV Presets 2 – 16 refer to the dome presets 2 – 16.