Symantec NETBACKUP 7 - Manual (Page 73)

To view deduplication storage server attributes
◆ Run the following command on the NetBackup master server or a
deduplication storage server:
UNIX: /usr/openv/netbackup/bin/admincmd/nbdevquery -liststs
-storage_server server_name -stype PureDisk –U
Windows: install_path\NetBackup\bin\admincmd\nbdevquery -liststs
-storage_server server_name -stype PureDisk –U
The following is example output:
Storage Server : bit
Storage Server Type : PureDisk
Storage Type : Formatted Disk, Network Attached
State : UP
Flag : OpenStorage
Flag : CopyExtents
Flag : AdminUp
Flag : InternalUp
Flag : LifeCycle
Flag : CapacityMgmt
Flag : FragmentImages
Flag : Cpr
Flag : FT-Transfer
This example output is shortened; more flags may appear in actual output.
Resetting the deduplication registry
If you reconfigure your deduplication environment, one of the steps is to reset
the deduplication registry.
See “Reconfiguring the deduplication storage server and storage paths” on page 63.
Warning: Only follow these procedures if you are reconfiguring your storage server
and storage paths.
The procedure differs on UNIX and on Windows.
73 Managing deduplication
Managing deduplication servers