Symantec NETBACKUP 7 - Manual (Page 44)

Table 4-1 How to replace the deduplication storage server host (continued)
Procedure Task
If you did not save a storage server configuration file before
the failure, get a template configuration file.
See “Getting the storage server configuration” on page 68.
Get a configuration file
template
See “Editing a storage server configuration file” on page 68. Edit the configuration file
Configure the storage server by uploading the configuration
from the file you edited. If you saved a configuration file
before the storage server failure, use that file.
See “Setting the storage server configuration” on page 70.
Configure the storage server
If you have load balancing servers, add them to the
configuration.
See “Adding a load balancing server” on page 58.
Configure the load balancing
servers
If you edited the deduplication configuration file, make the
same changes to that file.
See “About the deduplication configuration file” on page 60.
See “Editing the deduplication configuration file”
on page 60.
Change configuration
settings
See “Changing the deduplication disk volume state”
on page 77.
See “Changing the deduplication pool state” on page 77.
Change the disk volume state
and disk pool state to UP
See “Changing the deduplication disk volume state”
on page 77.
See “Changing the deduplication pool state” on page 77.
Change the disk volume state
and disk pool state to UP
If any backup jobs failed, restart those jobs. Alternatively,
wait until the next scheduled backup, at which time the
backup jobs should succeed. Restart the backup jobs
Uninstalling media server deduplication
The NetBackup deduplication components are uninstalled when you uninstall
NetBackup software.
However, you can disable media server deduplication and remove the configuration
files and storage files from the media server. The following procedure disables
Installing deduplication
Uninstalling media server deduplication 44