Sanyo POA-PN10 - Manual (Page 12)

12
Installation
[1] Mounting
1
Disconnect the AC plug from the
projector.
2
Remove all of the hole covers (3
round type, 4 square type) on
the rear of the projector and
insert plug on this product to the
DVI connector.
Mount as the SW lever on the
Unit presses the mount detect-
ing SW on the projector.
3
Tighten three screws by using a
coin etc.
✐ The AC cord must be disconnected from AC power outlet when mounting or removing this
product. It may damage the product.
✐ Do not connect the AC cord until after connecting the LAN cable and computer.
Caution !
Mount detecting SW
hole covers
Note:
This network unit is connected to the DVI ter-
minal on the projector, therefore, the digital
input does not be used when this unit is
mounted. The analog input of the Computer
2 can be used through the VGA terminal on
the network unit.
* Please use a VGA cable supplied with your
projector.
VGA cable
From computer