beautypg.com

Image adjustment – Sanyo Proj05 User Manual

Page 36

background image

Chapter 4 Controlling the Projector

Item

Description

Contrast .............................. Adjusts picture con-

trast. (0~ 63)

Brightness ......................... Adjusts picture bright-

ness. (0~ 63)

Color ...................................... Adjusts picture color

saturation. (0~ 63)

Tint ......................................... Adjusts picture hue.

(0~ 63)

BrilliantColor ................... Applies improved

color performance

with the BrilliantColor™

technology. (ON, OFF)

Color temp. ....................... Sets a color temperature

mode. (XLow, Low, Mid,

High, Adj.)

White Balance

Red, Green, Blue ..... Adjusts each white

balance respectively.

(0~ 63)

* When Color matching is set to

"On" and changing the "Target"

value of "Advanced color match-

ing", the color temp. indicates

"Adj."

Offset

Red, Green, Blue ..... Adjusts each offset

respectively. (0~ 63)

Sharpness ................................ Adjusts picture sharpness. (0~ 31)
Gamma .......................................... Adjusts brightness of darker part of the picture. (0~ 15)

Noise reduction ................ Switches noise reduction mode (ON, OFF)

Progressive ............................ Switches progressive mode (ON, OFF, Film)
Reset............................................Resets the Image adjustment to previous levels.

Store ............................................ Stores the Image adjustment values. Select an item [Image1 - Image10]

from the pull-down menu and click Store button.

Load image mode ............. Loads the Image mode. Select an image mode from the pull-down menu

and click Load button. There may not be available mode depending on the

input mode as shown in the table left.

Image adjustment

This function is to adjust the projected picture image and save the image mode. To store
the adjusted value, click Store button, and to load the adjusted value, click Load button.

Input source

Image mode Video Computer
Standard

4

4

Cinema

4

*

Real

*

4

Dynamic

4

4

Image1 - 10

4

4

✐ The mark "

4

" means that the available image mode in the

selected input source. The error message appears when

selecting the disabled image mode indicated with "*".