Sanyo Proj05 - Manual (Page 15)

15
ENGLISH
Network PIN code
The Network PIN code is to restrict the access to the projector through the network.
After setting the Network PIN code, you need to enter it to operate the projector via the
networks.
Network PIN code
1. Select "Network PIN code" in the Network menu, and press SELECT button.
The Network PIN code screen will appear.
2. Set the Network PIN code.
Set the figures with the Point ed buttons and move to the next items with the Point 7
8 buttons. Select “Set” and press SELECT button to set. To cancel the preset Network PIN
code, select “Cancel”. When you do not want to set the Network PIN code, set "0000".
It is recommended to set the Network PIN code if you use the projector via the networks.
The Network PIN code can be set also through the networks. See “3. Basic setting and
operation” ➔ “Initial setting” ➔ “Network PIN code setting” (p.23).
Network PIN code screen
Network factory default
1. Select a column with a red frame by using the Point 7 8 buttons.
2. Press the SELECT button. The screen 10-key pallet appears on the
screen.
3. By using the Point de7 8 buttons, select numbers 0 to 9 and press
SELECT button. By repeating the above to enter the complete
number on the column.
* To change the number in a column, select “C” and press SELECT
button to clear the number in the column and then enter the
number again.
4. After entering the number in the column, select a move key ( 7 8
e d ) located on the lower part of the pallet by using the point
buttons and press SELECT button repeatedly to move the red
frame.
5. Repeat steps 3 to 4 for entering all the network address.
6. After finishing, select “Exit” and press SELECT button. The 10-key
pallet disappears on the screen.
How to enter values with the screen 10-key pallet
Exit
10-key pallet
Move key