Sharp MD-MX30 - Manual (Page 34)

33
➁ Sleep timer setting
➀ Timer playback (record) setting
Timer playback
(record) start time
30 minutes - 2 hours Desired time
Sleep operation will
automatically stop. End time
To confirm the timer setting:
Press the TIMER/DELETE button once.
● The turn-on time, the turn-off time will be displayed.
To cancel timer operation:
1
While in the timer stand-by mode, press the ON/STAND-
BY button to turn the power on.
2
Press the TIMER/DELETE button repeatedly to turn off
the timer, "
f
PLAY" or "
f
REC" will go out.
Caution:
In the following cases, the timer recording function will not
work.
● When a MiniDisc has not been inserted.
● When a playback-only MiniDisc is inserted.
● When the MiniDisc you inserted is protected against acci-
dental erasure.
● When there is no recording space left on the MiniDisc you
have inserted (when the "TOC FULL" or "DISC FULL"
message appears).
■ Sleep operation
The radio, CD and MiniDisc can all be turned off automati-
cally.
1
Play the desired sound source.
2
Press the SLEEP button.
SLEEP
● If you do not need to change the time, the unit will enter
the sleep mode automatically.
3
Press the SLEEP button to select the time.
(Maximum: 2 hours - Minimum: 30 minutes)
The amount of sleep time can also be changed during the
sleep operation.
● 2 hours-30 minutes
→
30-minute intervals
SLEEP
4
The unit will enter the stand-by mode automatically
after the preset sleep time has elapsed.
To cancel the sleep operation:
Press the SLEEP button repeatedly. "0:00" will appear and
"SLEEP" will go out at the same time.
● The sleep operation will be canceled.
To confirm the remaining sleep time:
Press the SLEEP button.
Notes:
● Once the sleep time is set, it will remain the same duration
until the setting is changed.
● The sleep functions of this unit cannot be used to control
equipment connected to this unit. You must use the sleep
functions of the other equipment, if it has them.
■ Simultaneous sleep and timer operation
1
Perform steps 1 - 9 on page 42, "Timer playback/Timer
recording".
2
Perform steps 1 - 3 of the "Sleep operation" on this page.
(Continued)
SLEEP
ON/
STAND-BY