Sharp MD-MX30 - Manual (Page 20)

19
■ Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button.
3
Press the TUNER (BAND) button to select the desired
frequency band (FM ST, FM or AM).
FM ST FM AM
4
Press the TUNING (
X X X X X
or
W W W W W
) button to tune into the
desired station.
Manual tuning:
Press the TUNING (
X
or
W
) button as many times as re-
quired to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING (
X
or
W
) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
● When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
● If a weak station signal is found during auto scan tuning,
the station will be skipped.
● To stop the auto tuning, press the TUNING (
X
or
W
) but-
ton again.
5
To receive an FM stereo transmission, press the
TUNER (BAND) button so that the "ST" indicator on
the display lights up.
ST
● "
j
" will appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the TUNER (BAND)
button so that the "ST" indicator goes out.
● The reception changes to monaural, the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Notes:
● The last station tuned in will be recalled, even after chang-
ing the tuning band or the function, or after switching the
unit to the stand-by mode.
● If the unit's tuner interferes with the reception of a nearby
TV or radio, move the unit as far away from these items as
possible.
RADIO OPERATION
1
4
2,3,5
1
2,3,5