Sharp MD-MX30 - Manual (Page 21)

20
(Continued)
■ Preset tuning
You can store up to 40 stations in memory (40 stations con-
sisting of any combination of AM and FM stations you like)
and recall them.
To enter stations into memory:
1
Perform steps 1 - 5 in the "Tuning" section.
2
Press the MEMORY/ENTER button.
MEMORY
3
Within 5 seconds, turn the jog dial or press the PRE-
SET (
X X X X X
or
W W W W W
) button to make the preset channel num-
ber flash in the display.
● Store the stations in memory, in order, starting with preset
channel 1.
When
is displayed, a station has already been stored
in this preset number memory.
4
Within 5 seconds, press the MEMORY/ENTER button
to store that station in the selected station preset num-
ber memory.
MEMORY
● If the "MEMORY" and preset number indicators go out
before the station is memorized, repeat the operation from
step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station.
● When a new station is stored in the selected station pre-
set number memory location, the previously memorized
station in that location will be erased.
1
To scan the preset stations, press the PRESET (
X X X X X
or
W W W W W
) button for more than 0.5 seconds.
● The station preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds each.
2
Press the PRESET (
X X X X X
or
W W W W W
) button again to stop the
memory scan at the desired station.
Note:
When the preset memory does not have any stations stored
in it, the preset memory scan will not function.
To erase the memorized station:
1
Recall the memorized station to be erased by turning
the jog dial or pressing the PRESET (
X X X X X
or
W W W W W
) button.
2
Press the CLEAR button.
● "MEMORY" and preset number will flash.
3
Within 5 seconds, press the MEMORY/ENTER button.
4
Repeat steps 1-3 to erase other memorized stations.
To erase all memorized stations:
When the unit is in the stand-by mode, hold down the TUNER
(BAND) and the MD
■ buttons, and then press the ON/
STAND-BY button.
● "PRESET CLR" will appear.
To recall a memorized station:
Turn the jog dial or press the PRESET (
X
or
W
) button for
less than 0.5 seconds to select the desired station.
● The stations (preset channel number, frequency and fre-
quency band) which have been stored in memory will ap-
pear in the display in numerical order, irrespective of the
frequency bands.
Backup function:
The backup function protects all station presets for a few hours
should there be a power failure or the AC power cord is re-
moved from the AC outlet.
■ Preset memory scan
The stations saved in the preset memory can be scanned
automatically.
3
2,4
2,4
3
PRESET
(
X W
)
MEMORY/
ENTER
CLEAR