Shindaiwa 89309 - Manual (Page 7)

Choke closed
Throttle
interlock
Fast Idle
button
START
On/Off Switch
Throttle
trigger
Make sure the cutters are
clear of obstructions!
.Pull recoil
starter handle
upward
Hold the unit
¿UPO\
Slide the ignition switch to the ON postion
Start the trimmer by pulling the starting
handle rapidly outward
Set the choke lever to the CLOSED position if
engine is cold
Primer bulb
Return Tube
Press the primer bulb
Primer bulb
Return Tube
Press the primer bulb
7
Starting the Engine
Starting the Engine
IMPORTANT!
Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP.
Slide the ignition switch to the “ON” 1.
position.
Set the throttle lever to the “fast idle”: 2.
Depress and hold the throttle lock, a.
then squeeze the throttle lever
toward the handgrip on the shaft
tube.
Depress and hold the fast idle b.
button.
While depressing the fast idle but- c.
ton, release the throttle trigger.
Press the primer bulb until fuel can 3.
be seen flowing in the transparent
return tube.
WARNING!
Never start the engine from the operating position.
The cutting attachment will move when the engine accelerates!
Set the choke lever to the CLOSED 4.
position if engine is cold.
Place the unit on the ground. Grip the 5.
engine cover with your left hand and
the starter handle with your right hand
(shown).
IMPORTANT!
The primer system only pushes fuel
through the carburetor. Repeatedly press-
ing the primer bulb will not flood the
engine with fuel.
WARNING!
KEEP CLEAR OF THE CUT-
TING ATTACHMENT DURING START-
ING OPERATIONS! THE CUTTERS MAY
MOVE WHEN THE ENGINE IS STARTED!
Place the trimmer on the ground
Ŷ
during all starting operations.
Make sure you have a secure
Ŷ
IRRWLQJDQGNHHSD¿UPJULSRQ
the unit as well.
Keep all bystanders and pets well
Ŷ
clear of the trimmer during starting
operations.
IMPORTANT!
If the engine fails to start after several
attempts with the choke in the closed
position, the engine may be flooded with
fuel. Refer to the “Starting a Flooded
Engine” section of this manual.
Pull the starter handle slowly toward 6.
you until you feel the starter mecha-
nism engage.
Start the trimmer by pulling the start- 7.
ing handle rapidly outward.
This unit comes completely asembled.
Before using this product, please make
sure you have all the components
required for a complete unit. Carefully
inspect all components for damage.
Before starting the engine
This user manual
Ŷ
Tol kit including combination spark
Ŷ
plug/13mm wrench
Blade protecter
Ŷ
IMPORTANT!
The terms “left,” “left-hand,” and “LH”;
“right,” “right-hand,” and “RH”; “front”
and “rear” refer to directions as viewed by
the operator during normal operation of
this product.
CAUTION!
The recoil starter can be easily dam-
aged by abuse! Never pull the starter
cord to its full length.