Sampo DR-S0426 - Manual (Page 9)

7
SETUP MENU
SYSTEM SETUP
CAMERA SETUP
RECORD SETUP
ALARM SETUP
SCHEDULE RECORD
EVENT LIST
HDD MANAGEMENT
DEAFULT SETUP
EXIT
REC 30P 2005/MAY/16 10:20:30 MON
MOT [CAM1]O O[CAM2]
[CAM3]O O[CAM4]
[M] 231GB/239GB 97% [S] N/A
CHAPTER 3
SETUP PROCEDURES
0. LIVE VIEWING
Å---- STATUS BAR
Å---- INFORMATION BAR
STATUS BAR
Press ▲ button move from top or downgrade a
line, and how many recording FPS will show on the left
upper corner.
INFORMATION BAR
Press ▼ button move from bottom or upgrade a
line, by ◄ or ► button to change information
between HARD DISK STSTUS, RECORDING MODE and AUDIO RECORDING STATUS.
While MENU mode without press any key would go back to live viewing mode
after 2 minutes. And during live viewing for 5 seconds would go back to
recording mode automatically, if full time or alarm record set before.
1. MAIN SETUP MENU
Press the MENU button to go into the main
menu.
Use the ▲ or ▼ button to select items.
Press the ◄ or ► button to confirm the selection.
Press MENU to escape to exit the set up mode.
1. SYSTEM SETUP
System set up.
2. CAMERA SETUP
Camera set up.
3. RECORD SETUP
Recording set up.
4. ALARM SETUP
Alarm set up.
5. SCHEDULE RECORD
Schedule Recording set up.
6. EVENT LIST
Recording event list
7. HDD MANAGEMENT
Hard disk management
8. DEAFULT SETUP
Return to factory setting
9. EXIT
Escape from the setup menu.