Sampo DR-S0426 - Manual (Page 12)

10
RECORD SETUP
RECORD MODE MUX
NORMAL RECORD FPS 30P
ALARM RECORD FPS 30P
ALARM RECORD DWELL 10SEC
RECORD QUALITY HIGH
MOTION MIGRATION ON
EXIT
4. RECORD SETUP
Press ▲ or ▼ key on "RECORD SETUP" & ◄ or
► to enter:
Use the ▲ or ▼ button to select items.
Press the ◄ or ► button to confirm the
selection.
Press MENU back to SETUP MENU.
1. RECORD
MODE MUX/QUAD
Use ◄ or ► button to select MUX (multiplexer) or OD (QUAD) recording.
NORMAL RECORD FPS
1/2/3/4/5/7/10/15 & 30P
Use ◄ or ► button to select recording speed. 15P means 15 fields per second, 30P
is the highest speed, and 1P is the lowest. There are 1 / 2 / 3 / 4 / 5 / 7 / 10 / 15 &
30 you can choose, NTSC default 15P, PAL at 12P.
2. ALARM RECORD FPS 1/2/3/4/5/7/10/15 & 30P
Use ◄ or ► button to select alarm recording speed when external alarm or motion
detection is triggered. There are 1 / 2 / 3 / 4 / 5 / 7 / 10 / 15 & 30 you can choose,
NTSC default 30P, PAL at 25P.
3. ALARM RECORD DWELL 1~30SEC
Use ◄ or ► button to set the dwell time for alarm recording when external alarm or
motion detection is triggered. There are a total of 30 speeds you can choose from 1
to 30. When external alarm is triggered and within the dwell period: the screen will
be switched into quad mode. The corresponding camera will be marked ID "EXT" or
"ALM", default 10 seconds..
4. RECORD QUALIT BEST/HIGH/MEDIUM/LOW
Use ◄ or ► button to select the BEST, HIGH, MEDIUM or LOW setting so there is a
total of four levels of recording quality that can be chosen from. Higher quality &
higher the amount of storage will be consumed. Thus, this setting should be
carefully chosen as it will affect the usage of hard disk storage. A table at cheap 6
for relationship between quality, recording speed and hard disks is attached for
reference.
5. MOTION MIGRATION ON
Use ◄ or ► button to select add detected motion into event list or not, and the
default setting is on