Sharp XE-A303 - Manual (Page 10)

8
PREPARING THE CASH REGISTER
Unpack the cash register and make sure all accessories are included. For details of accessories, please refer to
“SPECIFICATIONS” section on page 99.
For installing the cash register, find a stable surface near an AC outlet where the cash register will not subject to
water sources or direct sunlight.
For preparing the cash register, please follow the three steps shown below; "1 Installing the Cash Register" on
page 8, "2 Initializing the Cash Register" on page 9, and "3 Installing Paper Rolls" on page 10.
Install the cash register using the fixing angle bracket provided with the register according to the following
instruction. The fixing angle bracket prevents the register from moving when the drawer opens. By hooking the
register on the bracket, you can secure the register to the position.
How to install the fixing angle bracket
1. Thoroughly clean the location where the fixing angle bracket
(B) is to be placed.
2. Peel off the adhesive tape on the fixing angle bracket.
3. Hook the angle bracket onto the hook (A) that is located at the
bottom rear of the register.
4. Firmly stick the fixing angle bracket to the table surface that
your cleaned above.
How to remove the register from the fixing angle bracket
1. Lift up the front of the register and pull the register towards
you.
STEP
2
1 Installing the Cash Register
A
B
A303_1(En) 06.7.22 9:20 AM Page 8