Woodstock SHOP FOX W1686 - Manual (Page 11)

ELECTRICAL
-9-
Extension Cords
We do not recommend using an extension cord
with 220V equipment. Instead, arrange the
placement of your machinery and installed
wiring to eliminate the need for extension
cords. If you must use an extension cord, make
sure it is rated Hard Service (grade S) or better.
The extension cord must always contain a
ground wire and plug pin. Always repair or
replace extension cords when they become
worn or damaged.
Grounding
This machine must be grounded! The electrical
cord supplied with the Model W1686 does not
come with a 220 volt plug. Use a plug with a
ground pin as shown in Figure 2. If your recep-
tacle does not accommodate a ground pin, have
it replaced by a qualified electrician or have an
appropriate adapter installed and grounded
properly. An adapter with a grounding wire
does not guarantee the machine will be ground-
ed. A ground source must be verified.
220V Operation
The SHOP FOX ® W1686 can also be operated at
220 volts. To do this, consult with the wiring
diagram in the back of this manual. Also, you
will need a NEMA-style 6-15 plug and recepta-
cle as shown in Figure 2.
The motor supplied with your new machine is
rated at 1 HP and will draw approximately 7
amps during 220 volt operation. When choosing
a circuit for this machine, consider using one
with a 10 amp double-pole circuit breaker or
fuse. Keep in mind that a circuit being used by
other machines or tools at the same time will
add to the total load being applied to the cir-
cuit. Add up the load ratings of all machines on
the circuit. If this number exceeds the rating of
the circuit wires or circuit breaker/fuse, use a
different circuit.
6-15P 6-15R
Figure 2. NEMA-style 6-15 plug and
receptacle.
NOTICE
Never replace the circuit breaker with one
rated at a higher amperage or damage to the
circuit may occur.
Any electrical outlet and cir-
cuit that you plug your
machine into must be
grounded. Never remove
the grounding pin from any
plug and always make sure
all wiring to the machine is
grounded before operating.
Serious injury make occur if
this warning is ignored!