Enhancing your system, Advance d feature s, Headphones – Sharp SD-EX220 User Manual
Page 27
27
SD-EX220
03/6/19
SD-EX220(U).fm
TINSE0560AWZZ
Advance
d Feature
s
-
E
n
h
a
n
c
ing your
syst
e
m
-
Enhancing your system
z
The connection cord is not included. Purchase a commercially available cord as
shown below.
z
Before connecting external units, set this unit to the power stand-by mode and turn
off the power to the external units.
Listening to the playback sounds from
VCR, DVD, etc.
Note:
To prevent hum interference, place this unit away from a television.
To record CD signals on external digital
audio recorders
The digital signal from this unit can be recorded by digital audio recorders, MiniDisc
recorders and other devices equipped with an optical digital audio input.
Notes:
z
When using the optical digital jack, remove the cap first. After using the jack,
replace the cap.
z
Only CD signals can be output.
Headphones
z
Before plugging in or unplugging the headphones, reduce the volume.
z
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
z
Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
(CD only)
VCR, DVD, etc.
Digital audio recorder
To the optical
line input jack
Connection cable for digital recording
(not supplied)
To the line
output jacks
RCA cord
(not supplied)
White
Red
Audio signal
Audio signal
1 Use a RCA cord to connect the VCR, DVD, etc. to the AUX INPUT terminals.
When using video equipment, connect the audio output to this unit and the video
output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUX button.
4 Play the VCR, DVD, etc.
1 Open the left side cover and then remove the DIGITAL OUT jack cover.
2 Close the left side cover (see page 13).
3 Use an optical connection cable for digital recording to connect the unit to the OP-
TICAL IN jack of digital audio recorders, etc.
4 Press the ON/STAND-BY button to turn the power on.
5 Put the MiniDisc recorder, etc. in the recording mode.
6 Play a CD on this unit.
Headphones
5