Sharp SD-EX220 - Manual (Page 15)

15
SD-EX220
03/6/19 SD-EX220(U).fm TINSE0560AWZZ
Prepar
ation for Us
e
-
To
inst
all t
h
e
main unit
and spe
ake
rs on t
h
e w
a
ll -
„ Installing speakers Notes:
z Place speakers with the tweeter on the outside. Left and right speakers should
always be positioned symmetrically.
z There are four VESA (*) screw holes on the back of the main unit and speakers.
You can also use commercially available fittings for mounting.
z Be sure to install the product according to the method recommended by the
bracket manufacturer.
(*) VESA (Video Electronics Standards Association) is an organization to promote
the standardization of digital imaging device for PCs.
1
Fix the pattern paper and drive two screws into the wall with a dis-
tance of 6-5/16" (160 mm) in between. When mounting vertically,
set the distance to 4-5/16" (110 mm).
2
Tighten the screws and remove the paper. Hook the speaker on the
screw heads and make sure it is secure.
Put the speaker wire in the groove on the back of the speaker.
Pattern paper
for speaker
(Horizontal position) (Vertical position)
6-5/16" (160 mm)
Pattern paper
for speaker
4-5/16" (110 mm)
(Horizontal position) (Vertical position)
Wall surface Wall surface
Speaker
wire
Speaker
wire
(Horizontal position) (Vertical position)
Tweeter
Tweeter Tweeter
Tweeter
(Main unit) (Speaker)
2