Sony FX52L User Manual
Page 46
46
Troubleshooting
Remote Commander
The picture from INPUT C
connector is colored
strange.
• Setting for Input-C Signal Sel. in the SET SETTING menu is
incorrect.
c Select Computer, Video GBR or Component for Input-C Signal
Sel. in the SET SETTING menu according to the input signal
(see page 34).
“Please check INPUT-C
setting.” appears in spite of
inputting the correct signal
from INPUT C.
• Setting for Input-C Signal Sel. in the SET SETTING menu is
incorrect.
c Select Computer, Video GBR or Component for Input-C Signal
Sel. in the SET SETTING menu according to the input signal
(see page 34).
On-screen display does not
appear.
• Status in the MENU SETTING menu has been set to Off.
c Set Status in the MENU SETTING menu to On (see page 35).
Color balance is incorrect.
• Picture has not been adjusted properly.
c Adjust the picture (see page 31).
• Projector is set to wrong color system.
c Set Color System in the SET SETTING menu to match the color
system being input (see page 34).
The picture is too dark.
• Contrast or Brightness has not been adjusted properly.
c Adjust the Contrast or Brightness in the PICTURE SETTING
menu properly (see page 31).
• The lamp has burnt or dims.
c Replace the lamp with a new one (see page 42).
The picture is not clear.
• Picture is out of focus.
c Adjust the focus (see page 24).
• Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
The image extends beyond
the screen.
• The APA key is pressed although there are black edges around the
image.
c Display the full image on the screen and press the APA key.
c Adjust Shift in the INPUT SETTING menu properly (see
page 33 ).
The picture flickers.
• Dot Phase in the INPUT SETTING menu has not been adjusted
properly.
c Adjust Dot Phase in the INPUT SETTING menu properly
Symptom
Cause and Remedy
The Remote Commander
does not work.
• The Remote Commander batteries are dead.
c Replace with a new battery (see page 16).
The menu display does not
appear even when you
press the MENU key on the
Remote Commander.
• The PJ/NETWORK select switch on the Remote Commander is
set to NETWORK.
c Set the PJ/NETWORK select switch to PJ, then press the
MENU key.
Symptom
Cause and Remedy