Sony DVP-K330 - Manual (Page 11)

11
Getting Started
DIGITAL IN
COAXIAL
OPTICAL COAXIAL
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL (AC-3)
COAXIAL
DIGITAL IN
OPTICAL
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL (AC-3)
OPTICAL
If you have a digital component such as a
receiver (amplifier) with a digital connector, DAT
or MD
Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied).
When you play a DVD, set “DIGITAL OUT” in “AUDIO SETUP”
to “ON” and then set “DOLBY DIGITAL” to “D-PCM,” “MPEG”
to “PCM” and “DTS” to “OFF” in the setup display. (page 55)
p When using an optical digital connecting cord
Take off the cap and plug in the optical digital connecting cord.
p When using a coaxial digital connecting cord
Notes
• Refer to the instructions supplied with the component to be
connected.
• You cannot make digital audio recordings of discs recorded in
multi-channel surround format directly using an MD deck or
DAT deck.
When you make the connections above, do not set
“DOLBY DIGITAL” to “DOLBY DIGITAL,” “MPEG” to
“MPEG” and “DTS” to “ON.” If you do, a loud noise
will suddenly come out from the speakers, affecting
your ears or causing the speakers to be damaged.
Optical digital connecting cord
(not supplied)
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
Coaxial digital connecting cord
(not supplied)
CD/DVD player
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
z
If you have a digital component with a built-in DTS, Dolby
Digital or MPEG decoder
You can enjoy multi-channel surround sound by connecting the
component via the DIGITAL OUT OPTICAL or COAXIAL
connector using an optical or coaxial digital connecting cord (not
supplied). For details on hookups and settings, see page 12.
Setups for the player
Some setups are necessary for the player depending on
the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 46.
• To listen to the sound through speakers connected
to a receiver (amplifier) having a digital connector or
to output the sound to a digital component such as
a DAT or MD deck
When you play a DVD, set “DIGITAL OUT” in
“AUDIO SETUP” to “ON” and then set “DOLBY
DIGITAL” to “D-PCM,” “MPEG” to “PCM” and “DTS”
to “OFF” in the setup display (page 55). These are the
default settings.