Scag Power Equipment TIGER CAT STC52V-25CV User Manual
Operator’s manual, Tiger cat
This manual is related to the following products:
Table of contents
Document Outline
- STC Operators Manual 03250 Rev 4 w-Spanish
- GENERAL INFORMATION
- SAFETY INFORMATION
- SPECIFICATIONS
- OPERATING INSTRUCTIONS
- 4.1 CONTROLS AND INSTRUMENT IDENTIFICATION
- 4.2 SAFETY INTERLOCK SYSTEM
- 4.3 INITIAL RUN-IN PROCEDURES
- 4.4 STARTING THE ENGINE
- 4.5 GROUND TRAVEL AND STEERING
- 4.6 ENGAGING THE DECK DRIVE (CUTTER BLADES)
- 4.7 HILLSIDE OPERATION
- 4.8 PARKING THE MOWER
- 4.9 AFTER OPERATION
- 4.10 REMOVING CLOGGED MATERIAL
- 4.11 MOVING MOWER WITH ENGINE STOPPED
- 4.12 RECOMMENDATIONS FOR MOWING
- 4.13 ADJUSTING CUTTING HEIGHT
- 4.14 Towing (optional hitch accessory)
- TROUBLESHOOTING CUTTING CONDITIONS
- ADJUSTMENTS
- MAINTENANCE
- ILLUSTRATED PARTS LIST
- 8.1 SCAG APPROVED ATTACHMENTS AND ACCESSORIES.
- 48V & 52V CUTTER DECKS
- 61V CUTTER DECK
- CUTTER DECK CONTROLS
- SHEET METAL COMPONENTS
- STC FOLDABLE ROLL-OVER PROTECTION SYSTEM
- STC SUSPENSION SEAT
- NOTES
- DRIVE SYSTEM COMPONENTS
- ENGINE & ATTACHING PARTS
- STEERING COMPONENTS
- BRAKE COMPONENTS
- WHEEL MOTOR PART NUMBER IDENTIFICATION
- NOTES
- FUEL AND HYDRAULIC SYSTEM
- ELECTRICAL SYSTEM
- BDP-10A HYDRAULIC PUMP ASSEMBLY
- REPLACEMENT DECALS AND INFORMATION PLATES
- ELECTRICAL SCHEMATIC
- LIMITED WARRANTY - COMMERCIAL EQUIPMENT