Sony HT-DDWG800 - Manual (Page 77)

77 GB
Ad
ditional Inf
o
rmation
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 27). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
Amplifier section
Power Output
1)
Models of area code CEL, CEK, AU
Stereo mode (rated) (6 ohms, 1 kHz, THD 1%)
90 W + 90 W
Surround mode (reference) (6 ohms, 1 kHz, THD
10%)
RMS output
2)
FRONT:135 W
per channel
CENTER:135 W
SURROUND:135 W
per channel
1)
Measured under the following conditions:
2)
Reference power output for front, center and
surround speakers. Depending on the sound field
settings and the source, there may be no sound
output.
Inputs
Analog Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
Outputs (Analog)
AUDIO OUT Voltage: 800 mV/
10 kohms
SUB WOOFER Voltage: 2 V/1 kohm
Reproduction frequency range:
28 – 20,000 Hz
Tone
Gain levels ±6 dB, 1 dB step
To clear See
All memorized settings page 27
Customized sound fields page 50
Area code Power requirements
CEL, CEK 230 V AC, 50 Hz
AU 240 V AC, 50 Hz
continued