SMC Networks SMC2835W - Manual (Page 18)

Section 8.1 | Configuration
When the Configuration Utility is initialized, the Configuration window may be immediately
shown. This will show you the current select profile of the wireless card. Click [New] to enter a
new name for the current profile. Click [Save] to save the current settings to the selected profile.
Click [Delete] to delete the current profile.
The options for Operating Mode are "802.11 Adhoc" and "Infrastructure". Adhoc networks consist
of wireless clients only. In Infrastructure networks, wireless clients connect to wired LANs via
Wireless Access Points. The options for Transmit Rate are "Auto", "1 Mbps", "2 Mbps", "5.5
Mbps", and "11 Mbps" for 802.11b networks. The options for Transmit Rate are "Auto", "1 Mbps",
"2 Mbps", "5.5 Mbps", "11 Mbps", "6 Mbps", "9 Mbps", "12 Mbps", "18 Mbps", "24 Mbps", "36
Mbps", "48 Mbps", and "54 Mbps" for 802.11g networks. The Channel can only be changed when
you are connected to a Adhoc WLAN. The channel must be configured to the same radio channel
as that used by the other wireless clients in your group.
For more secure data transmissions, it is recommended to enable WEP on your WLAN. The utility
supports HEX key entries. For the HEX Key Format, the security is enabled by entering 10-digit
keys for the 64-bit WEP configuration, and 26-digit keys for a 128-bit WEP configuration. Allowed
hex keys are 0-9, A-F and a-f. Select the desired encryption strength (64-bit or 128-bit) and then
enter the appropriate keys in Key 1, 2, 3, or 4. Remember to select the correct "Default Key" and
then click [Apply Changes]. You can also check the "Passphrase" option and enter the desired
value. You must be sure to use the same passphrase on all other wireless clients/Access Points. A
passphrase string can consist of up to 32 alphanumberic characters.