beautypg.com

Schumacher Power Converter X141B User Manual

Page 4

background image

• 4 •

NOTE: Do not use the converter with a product that draws a higher

wattage than the converter can provide, as this may cause damage

to the converter and product.

When you turn on a device or a tool that runs on a motor, the device

basically goes through two stages:

1. Start Up – Requiring an initial surge of power (commonly

known as the “starting load” or “peak load”).

2. Continuous Operation – Power consumption drops (commonly

known as the “continuous load”).

The wattage (WATTS) or amperes (AMPS) can normally be found

stamped or printed on most devices and equipment, or in the user’s

manual. Otherwise, contact the manufacturer to find out whether

the device you want to use is compatible with a modified sine wave.

To calculate the wattage: Wattage = AMPS x 120 (AC Voltage).

To calculate the starting load: Starting Load = 2 x WATTS. In

general, the start up load of the device or power tool determines

whether your converter has the capability to power it.

To calculate the continuous load: Continuous Load = AMPS x 120

(AC Voltage).

Always run a test to establish whether the converter

will operate a particular piece of equipment or device. In the event

of a power overload, the converter is designed to automatically

shut down. This safety feature prevents damaging the converter

while testing devices and equipment within the wattage range of

the converter.

When using the vehicle’s 12 volt accessory port, this

converter is designed to supply 60 to 70 watts when the vehicle is

not running. With the vehicle’s engine running, it can supply up to

100 watts. To use the full output, you must connect the converter

directly to your battery.

NOTE: The 100 watt limit is to accommodate the fuse ratings

for all vehicles. Some vehicles may allow the full output. If the

fuse blows when you switch on the device you are trying to use,

you have to either use a smaller device or you must connect the

converter directly to the battery.