Speco Technologies DVR-16/IP - Manual (Page 28)

27
Save/ Load Default
1 Load Installer Setting
2 Save Installer Setting
3 Load Factory Setting
4 Load Factory Password
5 Exit
Load Installer Setting
1 Save/ Load: No
2 Save/ Load: Yes
3 Exit
Engineer Set Up
1 Change Password 9999
2 Covert Cam Visible Yes
3 Playback Check OFF
4 Language English
5 Format Hard Disk
6 Exit
CD-RW Copy
1 B_Year 8 E_Year
2 B-Month 9 E_ Month
3 B-Day 10 E_Day
4 B_Hour 11 E_Hour
5 B_Min 12 E_Min
6 Play CD
13 Copy
7 Stop 14 Exit
6.8 Save/ Load Default
This menu allows you to restore the DVR-16/IP to the default
configuration, which was done by the installer (engineer), or the
factory setting.
6.8.1 Load Installer Setting
This item allows you to recall the “Installer’s Configuration” from the
on-board non-volatile memory.
6.8.2 Save Installer Setting
This item allows you to save the current setting as “Installer’s setting”. This operation can only
be executed with engineer password; otherwise, “Illegal Operation” message will be displayed.
6.8.3 Load Factory Setting
This item allows you to recall the “Factory’s Default” from the read only memory.
6.8.4 Load Factory Password
This item allows you to reload the factory password in case you forget your own password. The
initial factory password is 9999.
6.9 CD-RW Copy
This sub-menu allows you to export video to CD-RW. Select the start
time and end time of desired video and then press ENTER on 13
Copy to start copying.
Press the 6
th item to play the CD.
6.10 Engineer Set Up
If you enter the main menu with engineer’s password, you can enter
this menu.
6.10.1 Change Password
This password can be changed to any four-digit number use right/ left buttons to change to a
new number, press ESC button when finished, the password will be saved into non-volatile
memory. If the user forgets this new password, he can recall the factory password by using
Load Factory Password in Save Load Option sub-menu.