Siemens M55 - Manual (Page 110)

Notes A-Z
109
M55 Barracuda english, A31008-H6300-A1-1-7619 (30. April 2003, 10:40)
©
Siem
ens AG 2001
, I
:\Mob
il\L55\M
55_Barra
cuda\en\mit_
LG\f
ug\M55
_a
-z
.fm
Control codes (DTMF)
Send control code
You can, for example, enter control
codes (numbers) for remote access
to an automatic answering machine
while another connection exists.
These entries are transmitted direct-
ly as DTMF codes (control codes).
y menu§ Open call menu.
Send DTMF Select.
Use the Phonebook
Store phone numbers and control
codes (DTMF codes) in the Phone-
book/Addressbook in the same way
as a normal entry.
J
Enter phone number.
0
Press until a "+" appears in
the display (wait for the
connection to be estab-
lished).
J
Enter DTMF codes (num-
bers).
0
If necessary, wait again
for three seconds at a
time for the receiver to
process the entries safely.
J
Enter a name.
§Save§ Press.
You may also store just the
DTMF codes (numbers) and then
send them during the call.
Copy protection
Applications may be copy-protected.
Applications protected in this way
may only be run on devices for
which they are intended. It is, how-
ever, always possible to create a
backup copy of these applications on
your PC using the "Siemens Data
Suite" (p. 116).
CSD connection
(Circuit Switched Data)
Data is transferred via a data connec-
tion to a dial-in point pre-set by your
network operator or service provid-
er. This connection can be used for
exchanging data, such as, for exam-
ple, Internet access, or for down-
loading games and applications as
well as for using WAP services.
As long as you are using this connec-
tion for downloading applications
from the Internet or using services,
you must pay connection fees ac-
cording to your network operator’s
or service provider’s table of charges.